|
Filling the Mattress
|
Aereator Removal
From your bathroom faucet remove the aerator by unscrewing
it. If this faucet does not have an aerator, the kitchen
faucet may also be used. Sometimes a laundry or deep sink may
be used.
The last choice would be an outside faucet because you want
to put warm water into your waterbed mattress. A waterbed
mattress heater may take two days to bring a cold mattress up
to temperature. This could also strain the waterbed heater.
If the aerator is stubborn, wrap several layers of duct or
electrical tape around it to protect it from scratches and
use a pair of pliers to loosen the aerator. |
|
|
Hose
Attach the faucet connector from your waterbed care kit or
drain & fill kit to your faucet.
Firmly attach a hose to the faucet connector. Be sure this is
a clean hose. Hoses that have been stored outside for a
period of time, or that have dirt inside them may introduce
enzymes, bacteria, or other contamination into your waterbed.
Rinse these hoses for ten minutes by letting water run
through the hose. |
|
|
Mattress Attachment
Attach the waterbed hose attachment onto the hose. Remove the
fill cap and seal from the mattress and screw the attachment
into the fill hole. Be sure it is tight enough yet do not
overtighten and strip the threads. A small towel might be
handy to soak up any leakage from the filling process.
Fill the mattress with about 2" of luke-warm water.
Adjust everything one final time. Once the mattress is full
of water it will be impossible to move so check everything
carefully. |
|
|
Conditioner
Pour in your waterbed conditioner. Fill the bed until it is
1/4" to 1/2" below the side of the frame boards.
Shut off the water and remove the hose.
If you have Dual Mattresses split the conditioner between the
two bladders.
|
|
|
Air Removal
Remove the air from inside the mattress. Use a broomstick or
other rod, slide it from the head of the bed toward the fill
hole. Remove all the bubbles to prevent noise from the
mattress. A new mattress will periodically need to be
"burped" to remove the air.
Install the seal and cap.
|
|
|
How Much is Enough?
How much water is enough? This depends on the style of
mattress. The "1/4" to "1/2" below the
rail was only an approximation. Adding or subtracting water
can change the feel of the bed a great deal.
With fiberfilled (or baffled) mattresses rated over 95%
waveless, more water makes it appear softer and less water
makes it appear firmer. |
|
|
With a mattress of 90% or less waveless rating, the mattress
should be filled to accomodate the largest sleeper for the
bed. This is done by measuring with the body. Sit in the
middle of the bed. Rock gently to the left and right. If your
bottom only touches when you rock from side to side, it is
filled the correct amount.
If your bottom is always touching, add water. If your bottom
never touches, drain some water. |
|
|
