Decking


King Size

With am California King Size frame, position the three boards on the pedestal. Be sure the pedestal is equally recessed on all four sides so that the weight of the waterbed may be evenly distributed.

The cut corner(s) should be at the head of the bed so that the waterbed heater wires may pass under the frame and be plugged into an outlet. Do NOT install the heater at this point.

If your corners are not cut, trim off a triangular piece of the corner about 3" from the corner nearest the electrical wall outlet using a small handsaw or jigsaw.

 { step 1 }


Queen Size

The California Queen size typically has three boards of two sizes. Position the three boards on the pedestal with the narrower board in the middle. Be sure the pedestal is equally recessed on all four sides so that the weight of the waterbed may be evenly distributed.

The cut corners should be at the head of the bed so that the waterbed heater wires may pass under the frame and be plugged into an outlet. Do NOT install the heater at this point.		 { step 2 }


SuperSingle

The Super Single size typically has two boards. Position the boards on the pedestal with the narrower board in the middle. Be sure the pedestal is equally recessed on all four sides so that the weight of the waterbed may be evenly distributed.

The cut corners should be at the head of the bed so that the waterbed heater wires may pass under the frame and be plugged into an outlet. Do NOT install the heater at this point.		 { step 3 }

Next Step