Standard Riser
|
Layout the Riser
Layout the pieces of your standard pedestal inside the frame
as pictured. The finished sides when assembled will face
outside. These are often painted black. |
|
 |
|
Brackets
Slide the plastic corner brackets into each corner of the
pedestal base. Slide the corner bracket in at an angle to
start, for easier assembly. |
|
 |
| Firm pressure is usually required to slide the corner
brackets on. Do not use a hammer. |
|
 |
|
Supports
Assemble the two sets of the center support system by
inserting the slotted pieces into each other. Position the
two sets of center supports in the cnter of the bed head to
foot and side to side.
Alternately you may receive a single long support with two
shorter supports. Position it down the middle of the pedestal
base. |
|
 |
|
Center it again
The pedestal should be accuratly centered inside the frame.
Use a tape measure to ensure accuracy. |
|
 |
|
Remove the Frame
While not disturbing the pedestal, tilt one side of the frame
up and let it rest on its side. This is so you can place the
decking boards on top of the pedestal.
Step not required for many four post models.
|
|
 |
Next Step
|
