Quantum Solid State Waterbed Heaters - Install


lay out pad
  • Remove heater from package and unroll

  • Lay pad on decking - avoid seams between decking boards


  • Locate pad near foot of bed
runing wires

  • Run wire through corner gap at top of decking

  • Run sensor wire from controller - at least 12 inches away from heater pad

  • Plug heater pad into controller

mount controller
  • Mount controller on frame using two screws provided
  • Do Not plug heater power cord into wall socket until mattress is filled

 

Install safety liner and fill mattress with water before plugging heater control into wall socket.

WARNING - Do NOT fill mattress in Winter with Cold Water

A 300 watt heater does not have enough power to bring many hunderds of pounds of cold water up to temperature. If you like your mattress very warm, you should consider two heaters.

controller
  • Plug controller into wall socket
  • Set desired heat level

back